Nûçe نوچه‌
Mal> Çûna nava > Nûçe نوچه‌

Feydeyên pompeya magnetîkî ya germahiya bilind çi ne? ?

Time: 2022-12-19

  The high-temperature magnetic pump is a kind of non-contact torque transmission through a magnetic drive (magnetic coupling), so that the static seal replaces the dynamic seal, so that the pump is completely leak-free. Since the pump shaft and inner magnetic rotor are completely sealed by the pump body and the isolation sleeve, the leakage problem is completely solved, and the safety hazard of flammable, explosive, toxic and harmful media leaking through the pump seal in the refining and chemical industry is eliminated.

Composition of the pump

The high temperature magnetic pump consists of three parts: self-priming pump, magnetic drive and motor. The key component, the magnetic drive, consists of an outer magnetic rotor, an inner magnetic rotor and a non-magnetic isolation sleeve.

1. Permanent magnets:
Permanent magnets made of materials have a wide operating temperature range (-45-400°C), high coercive force, good anisotropy in the direction of the magnetic field, and no demagnetization will occur when the same pole is close to each other. It is a kind of Very good source of magnetic field.

2. Isolation sleeve:
When a metal spacer is used, the spacer is in a sinusoidal alternating magnetic field, and an eddy current is induced on a section perpendicular to the direction of the magnetic force line and converted into heat.

3. Kontrola herikîna rûnê sarbûnê
When the high-temperature magnetic pump is running, a small amount of liquid must be used to flush and cool the ring gap area between the inner magnetic rotor and the isolation sleeve and the friction pair of the sliding bearing. The flow rate of the coolant is usually 2%-3% of the design flow rate of the pump, and the ring gap area between the inner magnetic rotor and the isolation sleeve generates high heat due to eddy currents. When the cooling lubricating fluid is insufficient or the flushing hole is not smooth or blocked, the temperature of the medium will be higher than the working temperature of the permanent magnet, so that the inner magnetic rotor will gradually lose its magnetism and the magnetic drive will fail. When the medium is water or water-based fluid, the temperature rise in the annulus area can be maintained at 3-5°C; when the medium is hydrocarbon or oil, the temperature rise in the annulus area can be maintained at 5-8°C.

4. Plain bearing
The materials of magnetic pump sliding bearings include impregnated graphite, filled PTFE, engineering ceramics, etc. Because engineering ceramics have good heat resistance, corrosion resistance, and friction resistance, the sliding bearings of magnetic pumps are mostly made of engineering ceramics.
Since engineering ceramics are very brittle and have a small expansion coefficient, the bearing clearance must not be too small to avoid shaft-holding accidents.Since the sliding bearings of high temperature magnetic pumps are lubricated by the transported medium, different materials should be used to make the bearings according to different media and operating conditions.

Paqij bûn

  • Tel: + 86 21 68415960
  • Fax: + 86 21 68415960
  • Email: [email parastî]
  • Skype: info_551039
  • WhatsApp: + 86 15921321349
  • HQ: E/Building No.. 08 Pujiang Intelligen CE Valley, No.1188 Lianhang Road Minhang District Shanghai 201 112 PRChina.
  • Fabrîk: Maolin, wîlayeta Jinocuan, Bajarê Xuancheng, Anhui, parêzgeha, Chinaîn
沪公网安备 31011202007774号